GE WBVH5200 Manual Del Propietario E Instalación página 8

About the washer features.
NOTE:Features may not be available on all washer models,
Cycle Signal
Use the SIGNAL button to change
the volume of the end of cycle signal.
Pressthe button until you reach
the desired volume.
Prewash (on some models)
Prewash is an extra wash before
the main wash. Use it for heavily soiled
clothes or for clothes with a care label
that recommends prewashing before
washing. Be sure to add high-efficiency
detergent, or the proper wash additive
to the prewash dispenser.
NOTE:When selecting prewash,
it is recommended to use powder
detergent in the main wash !detergent)
compartment.
Extra Rinse
Use an extra rinsewhen additional rinsing
is desired to remove excess dirt and
detergent from soiled loads.
Delay Start
You can delay the start of a wash cycle
for 10-18 hours, depending on the model.
Pressthe DELAY START button to choose
the number of hours you want to delay
the start of the cycle, then press the START
button. The machine will count down and
start automatically at the correct time.
NOTE:If blouforget to fully close the door,
a reminder signa! wi!! beep reminding you
to do so.
NOTE:If blouopen the door when the de!as
is counting down, the machine wil! enter
the pause state. You must dose the door
and pressSTART again in order to restart
the countdown.
Lock
You can lock the controls to prevent any
selections from being made. Or you can
lock the controls after you have started
a cycle.
Children cannot accidenta!lbl start
the washer by touching pads with
this option selected.
To lock the washer, press and hold
the DELAYSTART button for 3 seconds.
To unlock the washer controls, press
and hold the DELAVSTART button for
3 seconds.
The control lock icon on the display will
light up when it is on.
NOTE: The POWER button can stil! be
used when the machine is locked.
_oLo 3 SEC _'_
TO STORE
MY CYCLE (on some models)
Tosave a favoritecycle,set the desired
settingsfor wash cycle,soillevel,spinspeed
and wash temp settingsand hold down the
MYCYCLE button for 5 seconds.A beep will
soundto indicatethe cycle hasbeen saved.
To use your custom cycle, press the
MYCYCLE button before washing a load.
To change the saved cycle, set the desired
settings and hold down the MY CYCLE
button for 3 seconds.
NOTE: When using MY CYCLE,wash
options cannot be modified after the
cgcle has been started.
NOTE:If blou change wash options with
MY CYCLEbefore starting the cycle, the
MY CYCLElight wi!! turn off and Sou wi!!
be returned to the base cgcle.
8
BASKET CLEAN
BasketClean is a cycle that freshens up
the inside of your washer.The cycle uses
bleach or other available washing
machine cleaners and more water to
refresh your washer. Use BasketCleen
once every month to reduce odor and
residue buildup inside the washer.
For more information on BasketClean,
refer to the Careand Cleaningsection
on page 12.