Idiomas disponibles
Idiomas disponibles
Setting the clamping force
If the quick release lever (2a) can be flipped too
easily, the clamping force is insufficient.
1. Turn the quick release lever in a clockwise
direction to increase the clamping force
(fig. G).
Note: If the quick release lever cannot be
flipped, the clamping force is too great.
2. Reduce the clamping force by turning the
quick release lever counter-clockwise.
3. Loosen the clamp one half turn and then try
to close the quick release lever.
4. Repeat this procedure until you find the
maximum clamping force at which the quick
release lever can still be flipped.
Adjusting the telescopic rod
You can set the telescopic rod at any desired
height.
We recommend that 2 people perform
the next step (height adjustment).
1. Turn the telescopic rod (3) to change the
position of the bicycle when clamped.
2. Open the quick release clamp (1d) on the
stand.
3. Set the telescopic rod at the desired height.
Note: Observe the maximum extension length
of the telescopic rod (3) and do not exceed the
indicated markings (3a).
4. As shown in fig. C, to fix in position insert
the Allen key (9) into the end of the quick re-
lease clamp (1b)/(1d) and turn it clockwise
until you feel a slight resistance.
5. Give it one more turn and then flip the quick
release clamp. When you flip it you should
feel stiff resistance.
6. Check the fixation.
Stabilising the front wheel
Attach the rubber connections (5) on the ends
of the front wheel stabiliser (4). Using the front
wheel stabiliser fix the front wheel in position
between the handlebars and the telescopic tube
(fig. F).
Tool tray
A magnet is located inside the large com-
part-ment of the tool tray for securing small parts.
Maintenance
Ensure that the hexagonal screws on the upper
tube connector are always tightly secured as
well. Check all parts of the bike work stand regu-
larly. Loose screw connections must be tightened
and defective parts replaced to avoid damage
to the product.
Storage, cleaning
When not in use, always store the product clean
and dry at room temperature.
Clean only with water and wipe dry afterwards
with a cloth.
IMPORTANT! Never clean the product with
harsh cleaning agents.
GB/IE
13
