Installing The Platform In Your Vehicle Iplatform - JANE iMATRIX Manual De Instrucciones

IPLATFORM
G. INSTALLING THE IPLATFORM IN YOUR VEHICLE
Not all systems are the same, therefore we advise you to test your
iPLATFORM in the car where it is going to be installed. To install the
platform, read your vehicle instruction manual, it will tell you which
seats are compatible with the platform. The iPLATFORM is compatible
with the ISOfix category D.
The anti-rotation leg (1) is an important safety feature, fit it correctly so
it is supported by the floor of the vehicle. If the leg support surface is
not the actual vehicle chassis (luggage compartment for example) do
not install the platform on this seat. To do this, follow the steps below:
Position the base on the seat with the anti-rotation leg (1) and the
fastening bar (9) unfolded. Extend the leg with the help of the upper
adjustment button (5a), until the window indicator shows OK and the
1
button changes to green. .a
Extract the ISOfix anchors (2) by turning the handle (4) on the side of
the platform. 1 .b
Guide both anchors (2) towards the ISOfix connectors of your vehicle
and press until both sides are locked. Two green signals on the
release buttons (3) will show you that they are correctly anchored.
If one or both of the signals are red, repeat this step.
Adjust the height of the leg (1) so that it rests on the floor of the
vehicle, the indicator on the base of the leg (10) and the indicator on the
leg adjustment button (5b) will turn green.
48
EN
To remove the platform:
Loosen the platform by turning the handle on the side of the platform (5).
Release the ISOfix anchors by pressing the buttons (4), the signal on
the buttons will turn red.
1 .c
1 .d
1 .f
WARNING: You will also find a specific list of instructions on the
!
platform.
1 .e