Idiomas disponibles
Idiomas disponibles
5.8.2 Deleting the pairing in the radio-controlled electrically coupled lock
1. Open battery compartment
2. Remove battery
3. Open the flap at the back of the lock
4. Insert the paring connector into the socket (protected against reverse
polarity by ribs at the sides)
5. Insert battery, the lock performs a pairing reset and then directly enters
the pairing mode (indicated by beeping for 30 s)
6. Remove the pairing connector out of the socket
7. Close the flap at the back of the lock
8. Close battery compartment
2
1
T15
5.8.3 Starting Service mode in the radio-controlled
electrically coupled cylinder
1. Remove the inside knob cap by means of the special wrench
2. Remove the battery
3. Unplug the motor connection cable
4. Insert the paring connector into the socket (protected against reverse
polarity by ribs at the sides)
5. Reinsert the battery and unplug the pairing connector within 4 seconds
The cylinder is in Service mode for 30 s. The status is indicated by a
continuous, slow beep
6. Plug the motor connection cable back in
7. Fix the inside knob cap by means of the special wrench
2
1
3
4
3
4
5
5
33
