Idiomas disponibles
Idiomas disponibles
ENGLISH
1. Junction box
2. Roof penetration
3. Cables
4. Mounting bracket
Maximum power (Pmax)
Voltage at Pmax (Vmpp)
Current at Pmax (Impp)
Open-circuit voltage (Voc)
Short-circuit current (Isc)
General instructions
Before using this appliance, read the operating instructions carefully.
Keep the manual for future use.
Assembly
Note: as soon as the solar panel is exposed to light or sunlight, the terminals in the junction box are energised. To avoid
short circuits when mounting and connecting the solar panels, you can turn the panels away from the light or cover
them so that they do not produce electricity during the assembly process. Remove the cover when the connection is
complete.
General assembly instructions:
1. Always mount the panel on a straight, flat surface. Do not bend or twist the panel.
2. Never try to disassemble the panel.
3. Avoid drilling or welding in the frame wherever possible.
4. Do not use sharp metal tools or other objects that may scratch the surface of the panel.
5. Install the panel horizontally or vertically with the junction box at the top.
6. Choose a location for the panel with as little shade as possible. Keep in mind that if the solar panel is shaded, the
power output will decrease.
7. Mount the panel so that air can circulate freely around it.
8. The supplied cables are already connected for you in the junction box. Do not disconnect it or swap the plus and
minus terminals.
9. Always connect the battery to the charge controller before connecting the solar module.
10. Check the system regularly to make sure it is functioning normally.
Determining location:
1. Determine the location for installing the solar panel, by placing it in the desired spot.
2. Mark this location and check that there is enough space around the panel.
3. Plan the laying of your wiring before proceeding with the installation.
Mounting:
1. Once you have checked your mounting location, you fix the panels to the desired location with the brackets, using
appropriate mounting sealant or glue. Follow the instructions on the packaging of the respective product.
MSSH-80
80 W
100 W
16.4 V
18.7 V
4.88 A
5.36 A
19.7 V
22.4 V
5.17 A
5.68 A
MSSH-100
MSSH-140
140 W
18.1 V
7.73 A
21.8 V
8.2 A
1
2
3
4
MSSH-180
180 W
17.6 V
10.26 A
21.1 V
10.88 A
