PNI Safe House 400 Manual Del Usuario página 6

EN
• Fix the screws well in the wall, then position the gas
detector.
• Avoid installing the gas detector near the following
sources: direct air flow caused by wind, fans, open doors
or windows, sources of steam, oil vapors, etc.
• Connect the solenoid valve according to the connection
diagram below.
Connection diagram
A
Instructions for use
• Choose the appropriate place to install the gas detector.
Follow the installation instructions.
• Power the gas detector to a 230V source. During the
priming period of the sensor, of about 3 minutes, the
B C
A - Power input
B - NC/NO
C - Solenoid valve output
6