Idiomas disponibles
Idiomas disponibles
Never store the tool with petrol in the tank inside a building.
Petrol vapours may come into contact with flames or sparks
and explode.
Store the appliance in a dry area with the fuel tank empty
and the fuel in a well-ventilated compartment. Avoid places
with high humidity to avoid the appearance of corrosion
and rust.
Clean the machine thoroughly before storage, especially in
winter. Keep the device in a good operating mode.
Make sure the device is protected against misuse use (for
example, by children).
Your device must only be repaired by the brand's technical
service or qualified professionals and only with original
spare parts.
1. Untighten the fixing and tightening screws of the rotating
shaft flexible hose (10) through the gearbox protection
holes (8);
2. Insert the A tip (9) of the flexible hose on the supporting
flange in the gearbox. Simultaneously, fit the rotating
shaft in the gearbox shaft's hole;
3. Spin the rotating shaft flexible hose so that the fixing
hole gets aligned with the gearbox fixing screw;
4. Tighten the fixing and tightening screws and make sure
the flexible hose is well tightened;
5. Adjust the rubber protection of the flexible hose fixation.
1. Untighten the fixing and tightening screws of the rotating
shaft flexible hose through the gearbox protection holes;
2. Insert the B tip (11) of the flexible hose (10) in the control
handle hole. Simultaneously, insert the rotating shaft of
the flexible hose in the control handle hole;
3. Tighten the control handle fixing screw in the flexible
hose.
1. Align the tightening ring hole with one of the three holes
of the rotating shaft's tube (4);
2. Fit the auxiliary handle lower rod in the tightening (15)
ring and match the holes;
3. Insert the auxiliary handle in the tightening ring.
The arrow on the handle must be facing away from the
cutting accessories holder and the pin on the handle fitting
must match the hole in the tightening ring.
4. Insert the screw, washer and fixing nut in the auxiliary
handle holes and tighten them clockwise.
The cutting accessories protection (2) avoids the projection
of loose objects and accidental contact with the user.
1. Adjust the fixing plate (16) in the cutting accessories
holder (17). Insert the washers and tighten the fixing
screws;
2. Install the cutting accessories protection on the fixing
plate;
3. Insert the screw in the fixing plate perforation and tighten
it in the cutting accessories protection;
4. Insert the flap (3) in the cutting accessories protection
base and fix it in the fixing sockets;
5. Place and tighten the fixing screw.
The
cutting
not protect the user against all objects (stones, glass,
cables, etc.) that are projected for the cutting accessory.
These objects can bounce off any surface and reach the
user.
Check the disc status before installing it. If damaged
(fractured, bent or cracked), replace it.
1. Place the supporting base in the rotating screw on the
cutting accessories holder (17);
2. Place the supporting base in the sprocket wheel of the
rotating screw;
3. Install the cutting disc in the supporting base. Assure
that the disc is installed with the blade pointing the
rotation movement;
4. Install the cover and the disc fixing nut in the fixing
screw. Tighten the nut counter clockwise with the wrench
supplied;
5. Remove the wrench from the accessories holder.
accessories protection does
