Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. OPERATION
5.1 Making Measurement
Before making any measurement, read the "SAFETY
INFORMATION" section with attention and remember
of all warnings. Always check the instrument regarding
damages, contamination (excessive dust, grease, ...)
and defects. In the case of any abnormal condition is
detected, do not take any type of measurement.
1. Press POWER button to turn on power, then display
will show 1% or 2%.
2. Remove the protective cover of sensor and press the
pins of two sides with fingers. The instrument is work
normally and can measure objects if the display value
is approx. 30%.
3. Insert the pins into the object approx. 5mm.
4. Press HOLD button to hold current reading. The H is
displayed. Press HOLD again to cancel hold function.
5. After measuring, press POWER button to turn off the
instrument, and cover the sensor pins.
NOTES:
1. The pins are very sharp. Don't let children play with
instrument.
6
Tabla de contenido
