Beacon Lighting Lucci air AIRFUSION RADAR Manual Del Usuario página 56

AIRFUSION RADAR – USING YOUR CEILING FAN
NOTE: The remote and receiver will need to be paired after the installation of the ceiling fan.
PAIRING REMOTE & RECEIVER – WHEN 1 DC CEILING FAN IS INSTALLED IN ONE LOCATION
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for the fan.
NOTE: Ensure power to the receiver is ON prior to pairing the remote with the receiver.
•
Turn OFF the mains supply to the fan by on/off wall switch.
•
Install the batteries into the remote. Please make sure the polarity of the battery is correct.
•
Turn ON the power to the receiver.
•
Press and hold the "
to the receiver of the ceiling fan.
If the fan has light kit attached, the light will flash on and off to indicate the paring process is activated.
•
Turn ON the fan and change the speed of the ceiling fan via the remote to check the operation and
successful paring.
•
If pairing has been unsuccessful, repeat these set of steps again.
PAIRING REMOTE & RECEIVER – WHEN 2 OR MORE DC CEILING FANS ARE INSTALLED IN ONE
LOCATION
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
If you want to control 2 or more ceiling fans with one remote, do as explained in the normal pairing
⚫
process, but make sure all ceiling fans wall switches are turned ON.
If you want to control them with individual remotes, do as explained in the normal pairing process, but
⚫
make sure the other ceiling fans wall switches are turned OFF. After the first fan is paired turn the wall
switch OFF and continue the normal pairing process with the next fan.
RESET TO DEFAULT:
•
Press and hold the "
ON to the receiver of the ceiling fan. After 3 seconds there will be a flashing light for learning code, after
10 seconds, the flashing light will be twice again, and then the remote will return to the original factory
condition.
54 | Page
" button on the remote for 5 seconds within 60 seconds of switching the power ON
" button on the remote for 10 seconds within 60 seconds of switching the power