PLAYTIVE SP-12198 Instrucciones De Uso página 9

• Inflate each air chamber until it feels
firm to the touch. When you press
with your thumb against the air cham-
ber it should still give a little.
Sequence
WARNING!
Follow the correct sequence when inflat-
ing the air chambers. Always inflate all
air chambers fully.
1. Main chamber (1a)
2. Slide with side walls (1b)
3. Slide padding (1c)
4. Ray (1d)
5. Seahorse (1e)
6. Bucket (2)
7. Fish (3)
8. Jellyfish (4)
9. Starfish (5)
3. Inflation
1. Fill the main chamber (1a) with air and close
the cap (fig. B). Inflate the air chamber until it
feels firm to the touch. When you press with
your thumb against each air chamber it should
still give a little. Close the valve seal.
2. To fill components 1b-1e and 2-5 open the
valve seal and inflate the air chambers. Close
the valve seal and push in the valve by press-
ing lightly (fig. C).
4. Garden hose connection
Screw the adapter (6) onto the product's water
connection (1f). Connect a garden hose using a
suitable hose coupling (not supplied) and attach
this to the water connection with the product's
adapter (fig. D).
Filling the product with water
Fill the product slowly and do not leave it unat-
tended while filling.
Note: Fill the product up to, at most, the printed
mark.
Important! Do not exceed the filling
capacity of 165l without water sprayer
attached!
Emptying the product
Open the drainage hole and allow the water to
run out (fig. E).
Note: Please follow the local regula-
tions regarding specific requirements
for disposing of water from swimming
pools.
Disassembly
Allow the product to dry completely before
folding it up.
Remove the garden hose. Take off all individual
removable parts.
Deflating the product
1. To deflate the main chamber rapidly, open the
seal (fig. F).
2. To deflate the other components pull out the
valve and squeeze the valve stem lightly so
that the air can escape or insert the deflation
tube into the seal to allow the air to escape
rapidly.
Repairs
Minor leaks or holes can be repaired with the
repair patch supplied.
Important!
Do not inflate the product for 20 min-
utes after repair! Do not use the repair
patch for leaks or holes on the seam.
1. Let the air out of the product completely.
2. Clean the area around the leak thoroughly.
The area must be dry and free from grease.
GB/IE
9