its packaging, always making use of suitable
equipment. Do not use the machine until all
the instructions provided in the "ASSEMBLY"
section have been carried out.
4.1 UNPACKING
1. Carefully open the packaging, paying attention
not to lose components.
2. Consult the documentation in the box,
including these instructions.
3. Remove all the unassembled parts from the
box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
Before assembling, make sure the
batteries are not inserted in their housing.
4.2 ASSEMBLY OF THE
CHARGING DOCK (Fig. 3)
NOTE The machine can be hung on the wall.
The batteries can be charged directly on the
machine with its charging dock (Fig. 3.A).
NOTE The charging dock can be fixed to the
wall (Fig. 3.B) (with the screws and the plastic
dowels supplied, Fig. 1. K) .
4.3 ASSEMBLY OF THE RAIL
FOR WALL FIXING (Fig. 4)
Once the rail (Fig. 1. H) has been fixed to the wall
(with the screws supplied), slide the charging
dock (Fig. 4. A) and the loop (Fig. 4. B).
4.4 ASSEMBLY / DISASSEMBLY
OF THE BLOWER TUBE
•
Align the blower tube (Fig. 5.B) with the air
outlet mouth of the drive unit (Fig. 5.A) and
push it all the way down so as to hook it
permanently.
NOTA Assembly is correct when the tab (Fig.
5.H) locks into place.
•
To remove the blower tube (Fig. 5.B) press
the release button (Fig.5. F.).
IMPORTANT Stop the machine and always
remove the batteries (Fig. 12) whenever the
blower tube is removed.
5. CONTROLS
5.1 START/STOP SWITCH
The start/stop switch (Fig. 6.A) performs two
functions:
1. it starts/stops the machine and, at the same
time, it engages/disengages the rotation of
the rotor;
2. it makes it possible to control the speed of the
rotor.
To start the machine, move the switch from the
stop position (Fig. 6.A.1) to the start position (Fig.
6.A.2).
Starting
simultaneous rotation of the rotor.
To stop the machine, move the switch to the stop
position (Fig. 6.A.1).
The rotor's speed must be adapted to the type
of work being performed (chapter 6.4.1) and can
be adjusted by moving the switch to the required
position:
– start position (Fig. 6.A.2) for average blowing
speed;
– high speed position (Fig. 6.A.3) for maximum
blowing speed.
6. USING THE MACHINE
IMPORTANT The safety rules to be followed
are described in chap. 2. Scrupulously respect
these indications in order not to run into serious
risks or dangers.
6.1 PRELIMINARY OPERATIONS
6.1.1 Checking and charging
the batteries (Fig. 7)
Before each use check the battery charge status
following the instructions provided in the battery
booklet.
NOTE The machine works only with both
batteries inserted.
EN - 7
the
machine
causes
the
