C. Handgrip: it makes it possible to control the
machine.
D. Battery (if it is not supplied with the machine,
see chapter 13 "accessories on request"):
device that supplies electric current to the
tool; its specifications and regulations for use
are described in a specific manual.
E. Battery charger (if it is not supplied with the
machine, see chapter 13 "accessories on
request"): device used to charge the battery;
its specifications and regulations for use are
described in a specific manual.
F.
Blower tube release button
G. Start/stop switch
H. Rail for wall fixing
I.
Charging dock
J.
Loop
K. Screws and plastic dowels supplied
IMPORTANT The machine works only with
both batteries inserted.
NOTE The batteries can be charged directly on
the machine with its charging dock.
3.3 PRODUCT IDENTIFICATION
LABEL (Fig.1 )
1. Name and address of Manufacturer
2. Type of machine
3. Sound power level
4. Conformity marking
5. Power voltage
6. Year of manufacture
7. Serial number
8. Article code
9. No load speed
Write the identification data of the machine in the
specific space on the label on the back of the
cover page.
IMPORTANT Quote the information on the
product identification label whenever you contact
an Authorised Service Centre.
3.4 SAFETY SIGNS (Fig. 2 )
The machine has various symbols on it.
Meanings of the symbols:
WARNING!
failure to use this machine
correctly can be hazardous for
oneself and others.
DANGER!
The
WARNING! Read the owner's
manual before using the machine.
Use ear protection devices and
goggles.
Do not leave the machine in the
rain (or in damp conditions).
PROJECTION HAZARD! Pay
attention to possible flying debris
projected by the air flow: which
may cause serious injuries to
persons or damage to objects.
PROJECTION HAZARD! People
or pets must be kept at least 15m
away when using the machine!
Remove the batteries before
any
m a i n t e n a n c e / a d j u s t m e n t
operation on the machine.
WARNING!
battery charger see the dedicated
manual
IMPORTANT Any damaged or illegible decals
must be replaced. Order replacement decals from
an Authorised Service Centre.
4. ASSEMBLY
IMPORTANT The safety regulations to follow
are described in chap. 2. Strictly comply with these
instructions to avoid serious risks or dangers.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling and
EN - 6
inspection,
cleaning
For
battery
or
and
