VDV Wire Tester / English
3.Description
3-1.Meter Description
1. LCD Display
5. Video Button
2. Data Button
6. Tone Button
3. Voice Button
7. ON/OFF Button
4. Cycle Button
8. Battery Cover
1
2
3
5
4
6
7
2
9. Video-F-Connector
10. Voice-RJ11/RJ12 Jack
11. Data-RJ45 Jack
8
9
10
11
3-2.Remote & ID's
1. Voice-RJ11/RJ12 Jack
2. Data1-RJ45 Jack
3. RJ45 Remote ID's, Permit Mapping 5 Remote Locations
4. F-Connector Remote ID's, Permit Mapping 5 Remote Locations
5. Data Patch Cable x 2
6. Coax Patch Cable
2
1
6
3-3.Symbols Used on LCD Display
1. Appears when testing or toning a phone cable.
2. Appears when testing or toning a network cable.
3. Appears when testing or toning a coax cable.
4. Indicates proper wiring on cable being tested.
5. Indicates the connections on one or more pairs is reversed at one of the cable.
6. Appears when the tester detects a properly wired cross over cable.
7. Appears when the cable being tested has a shield that is connected at both ends, the
Shield indicator will flash if there is a short between the shield and any wire within
the cable.
8. Wire Map Near End: The top row of numbers displays the connector pins on the
tester end of the cable in numerical order, these pins are mapped to the pins shown
directly below on the bottom row of numbers.
9. Wire Map Remote End: The bottom row of numbers displays the corresponding pin
numbers on the remote end of the cable, dash lines indicate shorted pins, no pin
numbers indicate an open pair.
VDV Wire Tester / English
4
5
3
3