Use Instructions; Troubleshooting Table - Pekatherm GU910 Instrucciones De Uso

Guantes calefactores

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

1) Open the glove pocket and connect the glove's jack to the connector on the battery. Introduce the

battery into the pocket and close the Velcro fastener.

Thanks to the extension cords you can place the batteries out of the gloves. Take the extension cords and

connect them to the gloves' jacks and then to the battery.

2) Put the gloves on and wait a few seconds to perceive pleasant warmth.

3) Let the product cool down before storing.

4) Unplug the battery from the gloves when not in use.

5) If the product is not to be used for a considerable time it is recommended to disconnect the batteries

and store them separately. In that case we recommend you proceed to half charge the batteries as explai-

ned in a specific paragraph of this manual.

BATTERY CHARGING

1) Make sure your mains rating corresponds to the stated on the charger's label.

2) Plug the charger output connectors into the batteries connectors and plug the charger into the mains

socket. (fig. 4) Red light on the charger indicates the start of charging.

NOTE: If LED indicator is off, please check whether the charger is plugged correctly into the mains socket.

Check as well if your mains socket has voltage.

3) Green light of the charger LED indicates the charging cycle is over. and that the batteries are fully char-

ged. In this case unplug them from the charger and from the mains socket to reduce consumption.

NOTE: Half charge the batteries before storing if they are not to be used for a considerable period of time.

Proceed as follows: completely discharge the batteries connecting them to the product as long as necessary,

and then put them to charge for about 2 hours and a half. Repeat the procedure at least once in half a year.

PROBLEm

make sure the batteries are charged and that have been properly connected to the

gloves. Glove´s male jack connector should be correctly inserted into the battery

connector.

1. The gloves

It may also be a question of appreciation. Remember that quick checks carried out are

do not heat

not reliable. Wait a few minutes to appreciate the heat more intensely.

If all previous steps fail and the gloves after a few minutes do not heat, take them to an

authorized service centre.

Before cleaning the gloves remove the batteries. Never wet the batteries.

The gloves cannot be machine washed.

For a basic cleaning of the gloves soft brushing is recommended. To get smaller stains out use a moist cloth

or sponge with some liquid soap or cleaning foam. Apply the foam regularly on the product's surface and

then brush it.

If washing is necessary remember that only hand washing is permitted. Use a soft detergent and rub or

brush softly avoiding wringing the product. After washing rinse the gloves properly and extend them flat or

hang them without folding. Do not iron the gloves.

According to EU Directive 2012/19/EC WEEE (Waste of Electrical and Electronic Equi-

pment), electrical and electronic devices must be disposed of separately from household

refuse, delivering them to a special refuse collection point, in order to assure the subse-

quent dispatch of the discarded equipment for recycling, treatment and environmentally

compatible disposal, thus contributing to the prevention of possible negative effects on the

environment and on health.

Your local authorities will provide you further information on how to dispose of your

inoperative appliances.

INSTRUCTIONS