Idiomas disponibles
Idiomas disponibles
Open the connection valves (10) on both sides of the pressure hose (11)
so that the levers are in the position shown in figure D, then place one
of the open valves in the compressor on the pressure hose connection
(16) as in figure F. Now close the valve by pushing the clamping lever (17)
downwards. Follow the same procedure when using the adapters (4-7).
Depending on the object to be pumped, select a suitable adapter and
press it into one end of the connection valve and then tighten the lever.
When disassembling, first pull back the clamping lever of the connection
valve and then remove the valve and adapter from the inflatable object.
NOTE: The pressure should be appropriately matched to the items being
pumped so as not to cause breakage.
NOTE: Air may escape from the pumped item valve when removing the
connecting valve. Remember not to remove the connecting valve too
quickly, additional pressure may need to be added to compensate for
escaping air.
5. Switching on/off
Press the POWER button (15) to switch the device on, pressing the
button again will switch it off.
6. Change of pressure units
To change the unit between bar, psi, kg/cm² and kPa briefly press the unit
change button (23) until the required unit is displayed on the pressure
unit indicator (22).
7. Pumping
When pumping with a user-set pressure, set the desired pressure value
using the pressure increase and decrease buttons (24-25), then the
value on the display will return to the current pressure value, to start
pumping press the start/stop button (26) - the pressure on the display
will increase to the set value. When the preset pressure level is reached,
the compressor will automatically terminate the pumping process; it is
always possible to terminate the process manually by pressing the start/
stop button (26).
ATTENTION: When pumping, the air hose and the connection valve get
hot, be careful when disconnecting the hose.
8. CAR/SUV pumping
The unit is automatically equipped with two pre-set target pressures:
Car - 2.40 and SUV - 2.80 (bar) - normal ambient temperature, Car - 2.30
and SUV - 2.60 (bar) - high ambient temperature and Car - 2.50 and
SUV - 3.00 (bar) - low ambient temperature. Please note that these are
indicative values only, the actual tyre pressure varies from vehicle to
vehicle so we recommend that you check your vehicle manual to find the
correct tyre pressure values. Press the car settings button (19) or the SUV
settings button (20). The set pressure will appear on the display (21) after
11
