HQ-Power HQ10001 Manual Del Usuario página 7

6. Operation
6.1 HQHZ10001
1. Make sure to fill the tank with hazer liquid.
2. Switch on the device.
3. Set the output level and press the manual button on the remote control to trigger the fog output.
The device will continue to output fog as long as the button is pressed.
You can also choose a continuous or timed output.
4. Switch off the device after use.
The manual fog button on the rear of the device must not be activated
6.2 HQHZ10002
Control Panel Description
FUNCTION enter the programming mode
VOLUME output volume control
TIMER start timer operation
MANUAL manual fog output
UP upwards through the menu list
DOWN downwards through the menu list
Preparing your Haze Machine
1. Remove the fluid tank from its compartment. Also, remove the cap.
2. Verify that the plastic hoses attached to the cap are in place and in good condition.
3. Pour fog fluid into the tank and close the tank.
4. Replace the tank into its compartment. Make sure the plastic hose entering the haze machine from
the fluid tank is not bent or kinked.
5. Connect the haze machine to the mains, switch it on and let it warm up. The haze machine is ready-
to-use after approximately 7 to 8 minutes.
In any operation mode, the display must read READY TO FOG to output
V. 02 – 19/01/2022
HQHZ10001/HQHZ10002
1. interval button
2. duration button
3. output button
4. timer button
5. continuous button
6. manual button
Buttons 1 and 2 only work in timer mode.
while activating the timer button on the remote control.
fog.
7 ©Velleman Group nv