Idiomas disponibles
Idiomas disponibles
1.
Lay the appliance carefully on its
back (with the door upwards).
2.
Unscrew hinge D/E (fig. 9), unscrew
the pin on the right and screw it on
the left (fig. 10).
3.
-Remove the freezer door (fig. 11).
4.
Unscrew hinge F (fig. 12) and mount
it on the left (fig. 13).
5.
Mount the freezer door (fig. 14).
6.
Screw hinge D/E (modified at point
2,3,4
P
agel4)(fig. 15).
7.
If your appliance is provided with a
base trim, refit it.
Reversibility of the handle
If the model has a fixed verrical or
horizontal handle, unscrew it from the left
side and screw it to the right side (fig. 16),
by moving the protecting plugs that close
-the~hötes.
Should the model have a hinged handle,
remove cover G (fig. 17) by unscrewing
the screw that is protected by a small lid.
Unscrew the handle L from the left side,
Position it on the right side and make the
4 fixing holes 0 3 mm by using the handle
it seif äs reference. Screw the handle to the
door and replace the cover G. Unscrew
the small contrasting block H from the
left and position it to the right, aligning it
to the handle and fitting it perfectly on to
the edge of the unit.
N.B. Do not use the drill to make holes
in the unit, the drill can be nscd to
make holes on the door.
Screw with the seif tapping screw supplied
(there are no previous holes). Seal the hole
on the left with the small plug supplied
separately. Insert the protecting plugs
(supplied in the small bag) into the holes
of the left side (fig. 18).
