Idiomas disponibles
Idiomas disponibles
SHE 16 18-EC
Continuous operation with engaged
switch rocker
Press switch (1.), push towards front (2.)
and engage at front end by applying
pressure (3.).
To switch off the power tool, release the
switch rocker by pressing the rear end.
NOTE
The power tool is equipped with accidental
start-up protection. If the battery is inserted
when the power tool is switched on, the
machine will not start up again.
NOTE
Overload protection: Switches the
–
machine off in the event of overload.
Temperature monitoring: The machine
–
will switch off if there is a risk of
overheating.
Operating instructions
NOTE
When it is switched off, the power tool
continues to run briefly.
Setting the distance between the
blades
The blade distance is set to a sheet metal
thickness of 1 mm when the machine is
delivered.
Check the distance of the blades with the
feeler gauge.
The following values must be set in order to
get optimal cutting results:
Sheet metal thick-
ness in mm
0.3–0.6
0.7–1.2
1.3–1.6
CAUTION!
The blades must not touch.
Setting the distance
Tap the on/off switch multiple times until
the upper blade reaches the bottom dead
centre.
Remove the battery.
Loosen the lower blade.
Set the blade to the required distance with
the adjusting screw and the Allen key.
Retighten the blade.
Slightly adjust the adjusting screw.
Check the distance with a feeler gauge.
Cutting
NOTE
The power tool may only be introduced to
the material to be machined when it is
switched on.
Keep the power tool inclined at an angle of
80°–90° to the sheet metal surface. Avoid
tilting to the side.
When cutting radii, work only with a low
feed, and do not tilt.
Blade distance in
mm
0.1
0.2
0.3
17
