Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Use EXTREME CAUTION when handling the appliance. When taking out of
package, it is recommended to lay the box safely on its side. For the most
part, the DIGITAL BOTTOM LOAD WATER DISPENSER is assembled. Once
unpacked and standing up right, the drip tray will need to be inserted.
Location Requirements:
1.
Install in the area where it is protected from the elements including direct sun.
2.
Install and use only on a hard, flat and level surface.
3.
Do NOT place the dispenser inside an enclosed space or cabinet.
4.
Position the dispenser no closer than 4 inches from the wall with at
least 4 inches clearance on the sides to permit free airflow.
5.
Service should only be performed by a certified technician.
WATER COOLERS
It is very easy to replace 3 or 5 gallon coolers (not included).
NOTE: Excessive weight hazard - It is recommended to use two or more
people to move and install bottles. Failure to do so can result in injury.
6.
Open up the cabinet door on the bottom and take the water cap off the water cooler.
7.
Place the siphon pump inside of the water jug so it's touching the bottom.
8.
Make sure the siphon pump cover cap fits securely over
the water jug top, ensuring no leakage.
9.
Close the door.
NOTE: There are two siphon tubes. The shorter tube is meant for 3
gallon jugs and the longer tube is meant for 5 gallon jugs.
WARNING: Make sure all fittings are tightened so there is no chance of a water leak.
HOW TO OPERATE
WARNING: This unit is intended for water dispensing only. Do NOT use
other liquids. Do NOT use for other purposes. Warranty is void if used
with any other liquids such as coffee, tea, juices, beer or wine.
This dispenser has been designed to use water bottles with a 3
or 5 gallon capacity. Do NOT use alternative bottles.
Initial Set Up
NOTE: Make sure that switches are OFF before loading in water. DO NOT flip the switches on until
a water jug has been installed. The Hot and Cold switches are on the back of the water cooler.
•
Follow the steps in ASSEMBLY to find a suitable location for the water
dispense and correctly install a water jug. Once those steps are followed,
flip the Hot and Cold water switches in the back of the unit to ON.
•
On the Control Panel, the Hot and Cold water indicator lights will flash
while water is heating and cooling. Once heating and cooling has finished,
the respective indicator lights will stop flashing and remain on.
NOTE: Make sure that switches are ON. Both the Hot and Cold
switches are located in the back of the water cooler.
7
