Idiomas disponibles
Idiomas disponibles
•
Between dispensing cycles, the water temperature will be
shown on the Display Screen in Fahrenheit.
Dispensing Cold Water
After setup, it may take up to one hour for the water to its maximum cold temperature. Once the
Cold-water indicator light has stopped flashing remains on, you can begin dispensing cold water.
1.
Place a bottle, glass, or pitcher below the water tap.
2.
Press the Child Lock button to unlock the control panel
3.
Press the Cold Water button to start dispensing water. A
countdown timer will be shown on the display screen.
NOTE: Press the Cold-Water button to cancel the countdown while dispensing.
4.
Repeat steps 2 – 3 to dispense more water.
Dispensing Hot Water
After setup, it will take a few minutes to reach the maximum hottest temperature Once the Hot
water indicator light has stopped flashing and remains on, you can begin dispensing hot water.
1.
Place a bottle, glass, or pitcher below the water tap.
2.
Press the Child Lock button to unlock the control panel.
3.
Press the Hot Water button to start dispensing water. A countdown timer will be shown
on the display screen. A countdown timer will be shown on the display screen.
CAUTION: Water will be EXTREMELY HOT. Avoid contact
with hands or skin as it may cause burns.
NOTE: Press the Hot Water button to cancel the countdown while dispensing.
4.
Repeat steps 2 – 3 to dispense more water.
Replacing An Empty Bottle/Low Water Indicator lights
Replace the bottle as soon as you notice that it is empty. The Low Water Indicator
Light will flash and the display will read "LW" when water is low.
HELPFUL TIPS
DISPENSER IS NOT WORKING
•
Make sure that the power cord is properly connected to a working outlet.
WATER IS LEAKING
•
Replace water bottle. Most common cause is a cracked bottle.
NO WATER IS COMING OUT
•
Make sure bottle is not empty. If so, replace it.
•
Make sure that you fully press the water control buttons.
WATER DISPENSER IS NOT COLD
•
Make sure cold switch is ON. Switch is located in the back of the water cooler.
•
It can take up to six hours after setup to dispense coldest water.
•
Make sure back of the dispenser is at least 4 inches from a wall
and that air is free to flow on all four sides of dispenser.
8
