Idiomas disponibles
Idiomas disponibles
Battery cover
To access the battery, press the plastic lock (19) and remove the battery cover
[Fig. 24].
Pump pressure regulator button
The pressure regulator button (21) can be found in the
component packaging.
It should be installed in the pressure regulator before use.
To install, just fit the plastic button (21) onto the
pressure regulator (20) [Fig. 25].
Filling the tank
To fill the tank, open the tank lid fully.
Make sure the filler neck filter and the filter at the bottom of the tank are installed properly.
Fill the tank with the desired product and close the tank lid. Make sure the lid has been closed properly before starting work.
Avoid overfilling to keep from spilling liquid during use.
Electric actuation (battery)
This equipment can be operated electrically (battery) or manually, using the lever.
A different hose coupling is required for each type of actuation. See "Installing the hose for battery operation" [page 14]
and "Installing the hose for manual operation" [page 15] for assembly.
With the battery charged and the hose connected to the bottom outlet, follow the steps below to operate in electric mode.
This equipment can be operated in two ways, via the I/O switch and the pressure regulator button.
• I/O switch: When turned to "I" position, it engages the pump at maximum pressure.
To turn the pump off, just press it to "O" position.
• Pump pressure regulator: Turn the pressure regulator knob (21) [Fig. 25] clockwise to determine the pump's operating
pressure. When the switch is turned to "I" position, the pump can be actuated via the pressure regulator button, as the button
is turned. To turn it off, turn it fully counterclockwise.
To turn the equipment off completely, both buttons must be off.
USE
19
Fig. 24
Fig. 25
EN
PT
17
17
