Idiomas disponibles
Idiomas disponibles
PT
EN
Rod lock
Fit the rod lock (15) into the top of the air chamber pump (8) so that the holes in the lock and the pump are aligned. This is the
only way to fit the rod into place [Fig. 16].
The upper part of the rod (13) must pass through the holes in the rod lock and the air chamber pump [Fig. 17].
Move the rod until you see the rod hole and insert the cotter pin to secure the rod [Fig. 18].
8
15
13
Fig. 16
Fig. 17
Fig. 18
Support strap installation
Insert the strap (16) into the hole "A" [Fig. 19].
Pass the strap (16) through the buckle (17) [Fig. 20].
Make sure the strap is secured [Fig. 21].
Fit the metal tip (18) at the bottom of the tank [Fig. 22].
Adjust the straps using the buckles to make the equipment fit comfortably.
A
18
16
17
16
Fig. 19
Fig. 20
Fig. 21
Fig. 22
Filter
To help prevent clogging in the nozzles, this equipment has a double filtration system.
Before using the equipment, make sure they are both properly installed.
The first filter is installed in the tank lid and must be kept in place, especially when refueling.
The second filter is at the bottom of the tank, positioned vertically in the tank's bore hole and keeping excessive impurities from
entering the hose, thus preventing clogging.
Never use the equipment without the filters being properly installed and cleaned [Fig. 23].
Fig. 23
16
16
