SANNOVER BYPSO VERTICAL Manual Del Usuario página 21

2. Pipe connection:
1. Electric water heaters must be installed on pipes and fittings of appropriate size and must be clean.
2. The water inlet pipe specification for this product is G1/2", and the threaded hole must be sealed with a
waterproof tape or sealing ring.
3. In order to facilitate the installation and removal of the water heater, it is recommended to install G1/2
fittings in the appropriate places of the water heater inlet and outlet pipes. Determine the location of the
water supply, connect the water supply pipe and the tap water pipe respectively to the water source, fill
the inner water tank and check if there are any leaks in the water pipe. If there is a water leak, the water
leak must be disconnected and corrected.
4. Install the safety valve with a nominal pressure of 0.7MPa (its interface is G1/2) on the water supply pipe
in the direction of the arrow on the safety valve (the arrow points towards the water heater). When the
water heater is powered and heated, the water in the tank is heated and expands. In order to reduce the
water pressure in the tank, a small amount of water droplets flows through the decompression port of the
safety valve. The decompression port must remain open to the atmosphere and must not be obstructed.
5. Method of installing the safety valve drain hose: screw one end of the drain hose to the safety valve; at
the pressure relief hole, the drain hose can be shortened or lengthened depending on the actual
situation, and the other end of the drain hose is connected to the drain to prevent dripping water from
splashing into the room when the pressure is released.
3. Electrical connection:
3.1 Electrical connections and wiring must be carried out by an experienced and qualified electrician.
3.2 The power wiring must comply with local regulations.
3.3 The electric storage water heater requires a power supply of 220-240V in single phase 9.1A (2000W).
3.4 Connect the power supply to the connector that provides the power supply to the electric storage water
heater. Make sure that the earthing terminal is firmly connected to the earthing connection.
3.5 The earth wire must be green and must be connected to the terminal bearing
3.6 All cables must be correctly connected and covered with sheaths.
Exhaust pipe
Handle
the earth wire symbol.
EN