Idiomas disponibles
Idiomas disponibles
Before using, it is necessary to ensure that the electric water heater is correctly and completely
installed. During the first use or after having emptied it, the electric water heater must be filled with
water before being connected to the electrical supply. Do not use this product if the electric water
heater is not supplied with water.
The electric water heater must be correctly and reliably earthed.
Before installation or use, you must read and understand the instructions and safety warnings. Failure
to follow instructions and safety warnings can lead to serious injury or even death.
Make sure that the power supply corresponds to the nominal power and frequency. To avoid the risk of
electric shock, ensure that the power plug is not damaged.
In order to avoid any danger related to an incorrect resetting of the temperature limiter, do not connect
this device to an external switching device (such as a timer or a circuit device controlled by public
facilities).
Ensure that the safety valve is always in working order to prevent the accumulation of pressure, to
prevent the backflow of water entering the electric water heater and to evacuate the excess pressure
when the internal pressure of the electric water heater is high, in order to guarantee the life of the
internal tank and to avoid accidents due to bursting. During the heating period, the decompression port
of the safety valve may drip water. This is a normal phenomenon. Do not close the decompression port
for this reason, in order to avoid serious safety accidents due to the inability of the electric water heater
to decompress.
If the pressure of the tap water used by the user is too high, the decompression port of the safety valve
can frequently release the pressure and evacuate the water. It is then necessary to install a pressure
reducer on the water supply pipe, and this pressure reducer must be installed in a place away from the
water heater.
Too high a water temperature can cause serious burns.
Before repairing or checking the electric water heater, make sure that the power is off.
The instructions for use must be placed next to or near the device in order for it to be possible for them
to be consulted later.
The method of draining the water in the inner tank: Make sure to disconnect the power plug and let the
temperature of the water in the tank drop to the natural temperature, or put the mixing valve in the hot
water position and let the cold water enter the inner tank until the water temperature drops to the natural
temperature. Close the water inlet valve, remove the water inlet pipe and the safety valve, put the
mixing valve in the hot water position or remove the water outlet pipe, then the water from the inner tank
can be discharged through the water inlet pipe. Warning: Be careful not to touch the water flowing from
the water outlet in order to avoid burns due to residual hot water.
EN
