Precaution
· The water heater must be earthed and must be connected to the independent single-pressure,
three-pin connector that is also earthed!
· At the first use, the water heater must be filled with water before being switched on.
· The safety valve, which is supplied with the water heater, must be installed on the inlet pipe of the
water heater!
If the temperature of the water you set is above 50°C, it can burn your body, so you must mix it with
cold water before using it.
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been supervised or
instructed in the use of the device by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
This appliance may be used by children aged 8 and over and by persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, provided that they have been
supervised or instructed in the safe use of the appliance and that they understand the risks involved.
Children must not play with the appliance. Cleaning and maintenance should not be carried out by
children without supervision.
Do not direct the spray head towards the human body when opening or closing the tap or adjusting the
water temperature in order to avoid being burned by a small jet of hot water.
The safety valve decompression vent temperature is high, which can cause burns on the body.
Before using this product, the safety valve supplied with the product must be installed at the water inlet
of the electric water heater. The maximum water pressure at the inlet is 0.7 MPa and the minimum
water pressure at the inlet is 0.02 MPa.
The effectiveness of the safety valve should be regularly checked to ensure that calcium carbonate
deposits are removed and that they are not blocked.
If the supply cord is damaged, in order to avoid any danger, it must be replaced by a qualified
professional.
Water can flow from the safety valve discharge pipe and this pipe should be left open to air. The
discharge pipe connected to the decompression device must be installed in a continuously downward
direction and in a non-freezing environment.
It is necessary to leave the socket accessible to disconnect the appliance from the power supply after
installation.
The appliance is intended to be permanently connected to the water distribution network and not to a
set of pipes.
EN