Idiomas disponibles
Idiomas disponibles
Paslode Cordless 16 ga. Straight
Lithium-ion Finish Nailer Operation
Cold Weather Operation: (Continued)
It will be necessary to repeat this procedure several
times until the temperature of the tool warms up enough
to operate in itʼs normal mode.
Once the tool reaches operational temperature the tool
will generate itʼs own heat and will function normally.
If the tool sits for an for an extended period of time and
cools down it may be necessary to repeat these steps.
During the warm-up process, never expose the
tool, fuel cartridge, or battery to flame.
The Cordless Finish Nailer should not be used
in the rain or where excessive moisture is present.
The use of the Paslode Cordless Technology under
these conditions may result in damage to tool
components and cause the tool to malfunction.
Operation:
WARNING
CAUTION
®
PRESS WORK –
CONTACT
ELEMENT
AGAINST THE
WORK SURFACE.
Fan motor starts,
fuel is injected
into combustion
chamber and
mixed with air
by the fan.
SQUEEZE
TRIGGER
Spark plug ignites
the fuel/air mixture
driving the piston
assembly down on
the fastener.
RELEASE
TRIGGER -
LIFT TOOL
Combustion
chamber opens.
Fan exhausts
hot gases and
cools internal
components.
The work contacting element and nose will become hot
after prolonged or rapid use. If it becomes necessary
to adjust the work contacting element, avoid touching
with bare hands.
This tool must be operated in a well ventilated environ-
ment, because the tool exhausts carbon monoxide
similar to a chainsaw or lawn mower. Exposure to
carbon monoxide may cause dizziness, nausea or
unconsciousness.
Depth of Drive Adjustment
Remove the battery before adjusting the depth of
drive.
The depth of drive adjustment is done by turning the
adjustment wheel as shown by the arrows on the side of
the tool.
DANGER
CAUTION
Turn
adjustment
wheel
in either
direction
13
