Idiomas disponibles
Idiomas disponibles
Mount the baby unit on dry wall (optional)
Notes
NOTE
NOTES
• Check for reception strength and cam-
era angle of the baby unit before drilling
the holes.
• The types of screws and anchors you
need depend on the composition of
the wall. You may need to purchase the
screws and anchors separately to mount
your baby units.
2. If you drill the holes into a stud, go
to step 3.
•
If you drill the holes into an object
other than a stud, insert the wall
anchors into the holes. Tap gently
on the ends with a hammer until
the wall anchors are flush with the
wall.
3. Align the wall mount bracket and screws with the
holes in the wall as shown. Tighten the screw in the
middle hole first, so that the wall mount bracket
position is fixed. You can tighten the other screw in
the top hole.
4. Place the baby unit on the wall mount
bracket, and then slide it forward until it
locks into place. Connect the power adapt-
er to the baby unit and a power supply.
1. Place the wall mount
bracket on a wall
and then use a pen-
cil to mark two holes
in parallel. Remove
the wall mount
bracket and drill
two holes in the wall
(5.5mm drill bit).
16
3. Insert the screws into the holes and
tighten the screws until only 6.5mm of
the screws are exposed.
OR
4. Place the baby unit on the wall
mount bracket, and then slide it
forward until it locks into place.
Align the holes on the wall mount
bracket with the screws on the
wall, and slide the wall mount
bracket down until it locks into
place.
5. You can maximize your baby unit's viewing angles by tilting the wall mount bracket.
Hold the baby unit, and then rotate the knob in anticlockwise direction. This will loosen
the joint of the wall mount bracket.
Tilt your baby unit up or down to adjust to your preferred angle. Then, rotate the knob
in clockwise direction to tighten the joint and secure the angle.
2
1
17
