Trevi EC 882 Guia Del Usuario página 10

ENGLISH
10
1 2 3 4
12
PREPARATION FOR USE
Insert the plug of the power cable into a 230V
until the time is set.
To maintain the time and alarm memory even during a momentary power failure,
insert two 'AAA' batteries in the battery compartment (11) at the back of the
device, observing the indicated polarities.
Note: during battery operation, the wake-up alarm does not work.
SETTING THE TIME
1. The digits will flash after connecting to power or press and hold down CLOCK
SET button (7) for approximately 3 seconds until the display flashes;
2. Press HOUR button (8) repeatedly to change the hour setting;
3. Press MINUTE button (9) repeatedly to change the minute settin;
4. Press CLOCK SET button (7) to confirm.
Note: If no button is pressed for a few seconds during the setting phase (flashing display),
the device will automatically return to fixed display mode.
SETTING ALARM TIME
Setting Alarm 1 and Alarm 2
This clock has dual alarms that can be set and used independently. The procedure
to set both alarms is the same. Follow the instructions below to set alarm time 1.
For alarm time 2, substitute "AL 1" button (2) with "AL 2" button (3).
1. Press AL1 button (2), the display, showing the alarm time, and the alarm indica-
tor LED 1 (12) will start flashing;
10_
11
5 6 7 8 9
13 14
CONTROLS DESCRIPTION
1. AL OFF button, alarm switch Off
2. AL1 button
3. AL2 button
4. button, Vibration
5. SNOOZE button
6. DIMMER button, display brightness
adjustment
7. CLOCK SET button
8. HOUR button, hour adjustment
9. MINUTE button, minutes adjustment
10. Speaker
11. Battery compartment (on the back)
12. Led Alarm 1 indicator
13. Led Alarm 2 indicator
14. Led indicator Vibration function
50Hz socket; the display will flash
EC 882