Idiomas disponibles
Idiomas disponibles
7. After the engine starts, move the throttle setting lever
to the idle position, then move the choke lever to the
open (
) position.
If the engine stops running before you move the choke
lever to the open (
) position:
A. Go ahead and open the choke.
B. Make sure the throttle setting lever is set to the idle
position.
C. Pull the starter grip until the engine starts.
BAD BOY
CAUTION
• Do not pull the Starter rope all the way out.
Hot Restart
To start the engine that is already warmed up (hot restart),
or if the ambient temperature exceeds 68°F (20°C):
1. Pump the primer bulb at the bottom of the carbureto r
until fuel can be seen flowing through the fuel retur n
line to the fuel tank.
2. Move the choke lever to the open (
move the stop switch to the "ON" position.
3. More the throttle setting lever to the idle position an d
4. If the engine fails to start after three to four pulls ,
To Stop The Engine:
1. Move the throttle setting lever to the idle position.
Handheld Blower
Operation
1. Allow the engine to warm up for a few minutes.
2. Control engine speed by the throttle trigger, or set the
) position an d
3. Operate lower speed to blow leaves or debris ground.
4. If the blow is not enough to blow, open the throttle
Note: Operate Handheld Blower at the lowest throttle
US- 13 -
pull the starter grip.
follow the instruction in the Cold Starting Procedur e
section (page US 12).
If the engine fails to start after you follow the abov e
procedures, contact an authorized BAD BOY
dealer.
Note: 1. Don't pull the starter cord out completely.
2. Do not release the starter cord fr om th e
fully extended position.
Release the throttle trigger.
Slide the stop switch to the "STOP" position.
engine speed by the throttle setting lever.
*To adjust the throttle setting lever.
Press the throttle trigger, then adjust the throttle
setting lever as you wish operation.
gradually.
setting to do the job.
