Idiomas disponibles
Idiomas disponibles
Maintenance and Care
4.7. Coolant
4.7.1. Coolant inspection
Turn off the engine and check the coolant level in the
reservoir when the engine temperature has cooled to room
temperature.
1. Place the motorcycle on a flat and firm level surface.
2. Keep the vehicle upright.
3. Check that the coolant level in the reservoir is between the
upper and lower level marks.
If the coolant level drops significantly or if there is no coolant,
there may be a break in the cooling system. Please do not
ride at this time, and send it to the designated repair shop for
repair in time.
Reservoir cover
Reservoir cover
Upper level
Upper level
Lower level
Lower level
52
4.7.2. Coolant addition
Coolant type: glycol-based engine coolant. Please use the
original antifreeze coolant. The use of other coolant/mixtures
that do not meet the requirements can cause damage to the
engine.
When the new vehicle leaves the factory, the coolant has
been installed, and attention should be paid to the inspection of
the coolant level in the expansion pot during maintenance.
When the coolant becomes turbid or reaches the mainte-
nance interval, please replace the coolant in time.
The coolant can only be added from the reservoir cap, and
remember not to open the radiator cap.
1. Remove the reservoir cap, add coolant and observe the
coolant level.
2. Tighten the reservoir cap again.
• Do not fill above the upper level mark.
Attention
• Do not allow foreign objects to enter the coolant
circulation system.
• Use the original antifreeze coolant. The use of other coolant that
does not meet the requirements may cause damage to the engine.
Do not open the radiator cap until the engine has
cooled to room temperature. Otherwise, high
Warning
temperature gas or liquid will spray out and cause
burns.
