Idiomas disponibles
Idiomas disponibles
Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to
the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all
other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No
dimmer or adjustable power supply.
The unit has a powerconnector output on board. Depending on the local conditions several units can be linked by powerconnector in- and output. Connect
a maximum of four (when using 230V/16A) units in a row. Use an approved three-core cable with a cross-section of at least 1.5 mm². The installation
instructions of the manufacturer and the colour coding of the cable must be observed. Do not turn off the unit by turning the powerconnector but use the
power on/off switch or schuko!
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
Place the unit on a flat surface.
Attached the pumpkin like the description below.
Fill the fluid tank with Beamz fog fluid.
Connect the power connector of the power lead in the plug of fog machine, then put the shucko in the outlet.
Turn on the machine and allow it to heat up. Heat up takes approximately 2,5 minutes and the LED on the backside of the machine will stay RED
colour. Once the machine has reached operating temperature the LED will coloured GREEN.
The machine is now ready for use, you can use it with the push button on top of the handle to activate smoke, leds and sound (when the
pumpkin is attached), or use the wireless remote like the description below.
Use only original Beamz fog fluid. Warranty will be voided if any other type of liquid is used, improper use of liquid may lead to
machine failure and malfunction.
ON / OFF (Smoke, Leds, ''Sound'' (when the pumpkin is attached))
ON / OFF ( Smoke only )
Led Macro, push for next modus. (push till last program to deactivate Led macro)
Push for sound (When the pumpkin is attached)
put the micro USB of the pumpkin carefully in the micro USB port of the smoke machine.
push the pumpkin carefully on the smoke machine like on the drawing below .
