Idiomas disponibles
Idiomas disponibles
TESTING DIGITAL LOCK
1. Push the safe door to the closed position and turn the knob counter clockwise to the left (Figure 1).
2. Enter the preset primary factory code "1 5 9" followed by "#" key into the keypad. If the correct code
is entered, the green LED will light up (Figure 2).
3. The knob can then be turned clockwise to the right to open (Figure 3).
NOTE: You have approximately 5 seconds to open the safe. If you wait any longer, the safe will
re-lock and you must re-enter the code to open the safe.
4. To lock, close safe door and turn knob counter clockwise to the left (Figure 4).
Figure 1
PROGRAMMING NEW USER CODE
1. Open door using the factory preset code of 159 followed by the "#" key (Figure 1).
2. Access the red reset button located on the inside of the door near the battery compartment.
Press the red reset button and the yellow LED will light up (Figure 2).
3. Enter a new 3-8 digit Primary user code followed by the "#" key. Press "*" to clear entry if wrong
digit is entered (Figure 3).
4. Safe will beep and yellow light will turn off (Figure 4).
5. You can now close and lock the safe door and your new User Code is now active.
NOTE: The factory pre-set code will not work after a new pass code is programmed.
Green LED
Figure 1
Green LED
Figure 2
Figure 2
Figure 3
Figure 3
3
Figure 4
Yellow LED
Beep
Figure 4
