Step 15
Carefully turn your unit over onto its front edges.
å
Unfold the BACK (P) and lay it over your unit.
å
å
Carefully cut out the perforated hole in the BACK (P).
Insert the end of the SAFETY STRAP through this hole.
Make equal margins along the top and bottom edges of the BACK (P). Then,
å
make equal margins along the side edges of the BACK (P). Push on opposite
corners of your unit if needed to make it "square".
Fasten the BACK (P) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHT (C).
å
NAIL
(51 used for the BACK)
Page 20
These holes must
1N
line up over the
UPRIGHT (C).
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
425011
Caution
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.
Safety strap
This hole
must be here.
P
www.sauder.com/service
