Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING:
DO NOT attempt to operate this walk-behind surface cleaner until you have read and understood
all safety warning and instructions listed in this manual.
Incorrect operation of this unit can cause serious injury!! DO NOT alter or modify this equipment in
any manner.
START-UP:
1. Lock the trigger gun on the surface cleaner by moving
the trigger lock to a 90° angle so it rests against the
handle grip (See Figure 8).
2. Ensure all connections are tight.
3. Turn on the water supply.
4. Release the trigger lock and run water through the
surface cleaner.
5. Start pressure washer according to manufacturer's
instructions.
SHUT-DOWN AND STORAGE:
1. Turn the pressure washer off.
2. Turn the water supply off.
3. Squeeze trigger gun to relieve the water pressure.
4. Disconnect and drain the water inside the pressure hose. Wipe down the unit and store in a
nonfreezing environment.
MAINTENANCE
A clogged or dirty nozzle will result in excessive pump
pressure causing a pulsing sensation and/or excessive
vibration.
1. Turn off the pressure washer and turn off the water
supply. Release the residual pressure by squeezing
the gun's trigger.
2. Disconnect the pressure washer wand from the
surface cleaner.
3. Using a 14mm wrench (not provided) remove both
nozzles from the spray bar. (See Figure 9)
Figure 8
Spray Bar
Figure 9
7
Trigger Lock
Nozzle
www.surfacemaxx.com
