Mains Connection - BH FITNESS G260 Instrucciones De Montaje Y Utilización

4. FITTING THE FOCUS BAR SIDE
COVERS TO THE FOOT BARS.-
Take the covers (150 and 151),
marked on the inside with the letter
"R", and position them at the end of
the foot bars with the inside of the
focus bars on the right hand side, as
shown in Fig.5.
Now use screws (155) (62) to attach
them.
Carry out the same procedure using
the covers (150 and 151) marked on
the inside with the letter "L".
Next, release the screws (5 and 9) of
the main post (4), take bottle holder
(72), and insert it in through the top of
the post (4) in the direction of the
arrow. Attach the bottle holder using
screws (5 and 9) previously removed.
5. FITTING THE HANDLEBAR.-
Bring the handlebar (44) up to the
handlebar stem (4), Fig.7, insert the
hand-grip cable (49) in through the
slot as shown in Fig.7, and pull it out
through the top of the handlebar stem.
Insert screw (158), put the washer
(159), then fit the bracket cover (149).
6. FITTING THE ELECTRONIC
MONITOR.-
Bring the monitor (1) to the handlebar
stem (4) Fig.7, connect the two
terminals (19/49) coming out of the
handlebar stem (4) and the monitor (1)
Fig.8.
Insert the monitor
handlebar stem (4), as shown in Fig.8,
making sure not to pinch any of the
cables. Fit the bolts (3) along with the
flat washers, securely tighten.
(1) onto the
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (86) up or down, as
shown in Fig.9.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (83),
as shown in Fig.10, which make it
easier to move. The two wheels at the
front of the unit make it easier to place
the unit in to any chosen position by
lifting the rear slightly.
Store your unit in a dry place,
preferably not subject to changes in
temperature.

MAINS CONNECTION

(optional).-
Insert the jack for the transformer
(160) into the connection hole on the
main body (bottom, rear of the
machine)
transformer (160) into a 220 V mains
supply, Fig.11.
Note: The
necessary to charge the battery after
long periods of inactivity. Disconnect
the transformer
machine.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
15
and then plug
transformer
before using
the
is only
the