Idiomas disponibles
Idiomas disponibles
2. Attach the downrod to the fan motor housing
Loosen the two set screws (QQ) on the
2.1
fan motor housing (G), and remove the
locking pin (PP) and hanging pin (OO)
from the downrod (E).
E
OO
QQ
Carefully feed the motor housing
2.3
(G) wires up through the downrod
(E).
E
G
INSTALLATION
2.2
PP
QQ
G
2.4
8
Remove the hanger ball (D) from the downrod (E)
by loosening the hanger ball screws (NN) and (VV),
and removing the cross pin (MM); then slide the
hanger ball (D) off the downrod (E).
VV
D
E
Insert the downrod (E) into the fan motor housing
(G). Align the holes and replace the hanging pin
(OO) and the locking pin (PP). Tighten the two set
screws (QQ).
Note: If you feel resistance while pushing in the
hanging pin, push cable wires aside.
E
OO
G
CAUTION: TO AVOID DAMAGE AND TO ENSURE
!
A WOBBLE-FREE OPERATION, THE DOWNROD
AND MOTOR HOUSING SET SCREWS MUST BE
FULLY TIGHTENED UNTIL YOU FEEL RESISTANCE.
WARNING: FAILURE TO PROPERLY INSTALL THE
!
MOTOR HOUSING LOCKING PIN COULD RESULT
IN THE FAN BECOMING LOOSE AND POSSIBLY
FALLING.
MM
NN
D
E
PP
QQ
