Idiomas disponibles
Idiomas disponibles
5. Wire the fan
Insert the receiver (H) as shown, into the mounting bracket (A)
5.1
After the receiver (H) is placed in the bracket (A), connect the four-pin and two-pin wires
together.
A
WARNING: ALL WIRING MUST BE IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE, ANSI/NFPA 70. IF WIRES AT
!
THE INSTALLATION SITE ARE ANY OTHER COLOR THAN WHAT IS LISTED HERE, HAVE THIS FAN INSTALLED BY A QUALIFIED
ELECTRICIAN.
WARNING: THE CEILING FAN MUST BE GROUNDED. IF THERE IS NO GROUND WIRE PRESENT ON THE INSTALLATION SITE
(EXAMPLE, FROM THE CEILING), STOP THE INSTALLATION IMMEDIATELY AND CONSULT A QUALIFIED ELECTRICIAN.
!
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DISCONNECT THE ELECTRICAL SUPPLY CIRCUIT TO THE FAN BEFORE
WIRING. IF YOU DO NOT FEEL YOUR ELECTRICAL WIRING KNOWLEDGE OR EXPERIENCE IS SUFFICIENT, CONTACT A
QUALIFIED ELECTRICIAN. CAUTION: DO NOT INSTALL IN A DAMP OR WET LOCATION, THIS FAN IS FOR INDOOR USE ONLY.
INSTALLATION
H
11
A
H
