Idiomas disponibles
Idiomas disponibles
Erkopress 240
Moulding pot with sup-
port cross, model disc
lifter and pot ventilation.
*
Note below!
Handling of form pot, model disc and the placement of the models:
Bottom side of the form
pot with transverse
groove
Use model disc only
with carrying cross!!
Notes on model arrangement and model height:
The models must be at least 1 cm apart for model heights up to approx. 1.5 cm. For models higher
than 1.5 cm, the distance should be 1.5 cm. If the models are of different heights, the final thickness of
the splints will be thinner for the higher models. As a rough guide, 1 cm of model height corresponds
to 20 - 25 % loss of thickness. Models of very different heights should therefore not be moulded
together.
Unit components:
2 model discs, back
side each with cone
*
Note page 10!
Counterpart to the
groove on the form
pot table
Depending on the model size, up to 9 models can
be placed. Left image, model disc with cone for
foils over 1.0 mm thick.
*
To facilitate removal of the model plate, push the lifter for the model plate
upwards after shaping. for the model plate upwards after moulding.
Mould pot with lifter for
the model disk O.
The form pot must be placed on the forming
pot table with the transverse groove in the
counterpart
Foil-reception (1) and
foil securing ring (2)
2
1
The models must not
extend beyond the
marked ring
5
