Idiomas disponibles
Idiomas disponibles
3. "COOLING" Touch
Note:
don't use this button without water, to avoid damage to parts.
Press the button, the water pump start to work, the wind will be cooler and wet.
3-1 Before operating the unit in Cool mode, make sure the escape valve for the
water tank is properly fixed. Then proceed to add clean water into the water tank.
While adding the water, make sure that you keep an eye on the water level
indicator to make sure that you do not OVER or UNDER FILL the unit. Press the
button Cool after you have added the water and the unit should commence to
blow cooler air. When you press the button Cool again, it will stop working.
3-2 lf you find that the air after Step 1) is still not cool enough, you can add
additional ice block into the water tank directly by opening the water tank cover.
Be sure not to exceed the icebox capacity otherwise damage to the unit or electric
shock may occur.
3-3 lf you wish to use an Ice box instead of ice block, j ust place it directly into the
tank by opening the water door. lt will be good cooling efficiency if you place it in
your refrigerator and let the ice pack freeze for 1 to 2 hours.
3-4 You may complete pull out water tank, then replace water in the water tank or
clean water tank.
4. How to knock down the dust-proof bracket and honeycomb filter.
�----------
1. Rotate the small knob updown
3. Take out the Honeycomb
panel trame.
24
