Boston SoundWare XS 2.1 Manual Del Propietário página 6

E
N
G
L
Line Level
I
S Select "subwoofer-yes" from your receiver's set-up menu. If the receiver gives a choice of crossover filter frequency, use 150Hz
H
or 120Hz. Hooked up this way, the receiver's amplifier is relieved of having to reproduce the difficult low bass signals that can
drive the receiver into audible distortion. In some cases, it can also depend on several other settings within a receiver. We
recommend consulting your receiver manual for further assistance in this area.
Turn off all power. Use a subwoofer cable, as shown, to connect your digital receiver's LFE subwoofer output to the subwoofer.
Connect the other end to the Line Level In.
Receiver
Operation
Power On/Off
Plug the subwoofer's AC cord into a wall outlet. Do not use the outlets on the back of the receiver. Set the power switch to
the desired setting.
OFF
– The subwoofer is off and will not produce any sound. You may want to turn your subwoofer off if you will not be using
it for some time or wish to conserve electricity.
ON
– The subwoofer is always on. If no signal is detected after several minutes, it will automatically enter the Mute mode.
An LED indicator indicates what mode the subwoofer is in:
OFF
– The subwoofer is off
RED
– Mute (No signal detected, Amp Off )
gREEN
– Audio On (Signal detected, Amp On)
The subwoofer will automatically enter the Mute mode after several minutes when no signal is detected from your system.
The subwoofer audio will then turn ON instantly when a signal is detected.
Crossover Control
Adjusts the frequency of the low pass filter for the subwoofer Speaker Level Input. Set the crossover control on the subwoofer
to 180Hz. Note: This control is not active when using the LFE input jack.
Volume Control
Turn the subwoofer Volume control to the 9 o'clock position. If the subwoofer makes no sound, check the AC-line cord, Power
switch, and input cables. (Are the connectors on the cables making proper contact? Is the AC-line cord connected to a "live"
receptacle, is the subwoofer in either the Auto or On position?)
Adjust the subwoofer Volume control until you hear a match between the main speaker and subwoofer. Bass response should
not overpower the room but rather be adjusted so there is a natural blend across the entire musical range.
Polarity Control
(0° or 180°): Selects regular (0°) or inverted (180°) phase for the subwoofer. Set this switch to provide the fullest, most
dynamic bass. The effect of phase will be most audible on low-frequency percussion instruments or music with a
continuously repeating bass line.
6
Subwoofer Ampli er