Locate Charger; Battery Type & Settings; Charging - Carpoint 0635863 Manual De Instrucciones

short-circuiting.
• Disconnect the battery from the charger when charger is not connected to the power supply.
This will reduce back drain current.
• Charging must be ceased immediately if battery is found to be too hot or leaks out liquid
during charging.
• In case of malfunction or damage, immediately disconnect the charger from the mains.
• Do not use vehicle when charging permanently installed batteries.
• Ensure that charger switches to maintenance charge mode, before it is left unattended and
connected for long time. If this stage does not arrive within 73 hours (max), the charger must
be disconnected manually.

Locate charger

• Locate the charger as far away from battery as the DC cord permits.
• While charging do not place charger directly above or below the battery. Gases or fluids from
the battery may corrode and damage the charger.
• Never allow battery acid to drip on the charger.
• Charging should be carried out in a well-ventilated, weather protected facility.
BatterY tYPe & SettIngS
The following recommendations should only be referred to as guidelines. For precise details, you
must refer to battery manufacturer for instructions.
Symbol mode

chargIng

1) Charging of a permanently installed battery in a vehicle
a) Before connecting or disconnecting the battery leads, the power cord should be removed
from the mains.
4
Settings
1 7.2V/1.0A
2 14.4V/1.0A
details
This mode is normally suitable for 6V (1.2Ah to
12Ah) WET/Flooded, GEL, AGM, MF, VRLA type
lead-acid rechargeable batteries.
This mode is normally suitable for 12V (7.2Ah to
60Ah) WET/Flooded, GEL, AGM, MF, VRLA type
lead-acid rechargeable batteries.