Maintenance Charge; Error Mode; Power Mode - Carpoint 0635863 Manual De Instrucciones

battery) or 14.4V±0.25 (for 12V battery), battery is fully charged and ready to use. It is
indicated by green LED
10 . The charger switches to maintenance charge phase.
Standby feature: When battery remains connected with vehicle's wiring system, during the
trickle mode, circuits continuously monitor the current drawn by the battery.

5) maintenance charge:

Charger begins maintenance charging pulse at constant 100mA to support any connected
accessories or losses due to deterioration vehicle wiring until voltage reaches 6.8V±0.125V
(for 6V battery) or 13.6V±0.25V (for 12V battery).
Green LED
10
6.15V±0.125V (for 6V battery) or 12.3V±0.25V (for 12V battery). If the battery is loaded
and/or terminal voltage falls below 6.15V±0.125V (for 6V battery) or 12.3V±0.25V (for 12V
battery), the red LED
This Carpoint charger is fully interactive which adjusts itself to changing current requirement to
charge and maintain the battery.

error mode

The charger goes to Error mode in following situations:
a) After charging, battery's voltage is not sustained or despite recovery attempts the battery was
irrecoverable. This may be due to a defect in the battery itself such as a short-circuited cell or
total sulfation.
b) If battery is still connected to the vehicle's wiring system, there may be loss of current
through deteriorating wiring or a degraded switch or contact or in-circuit current-consuming
accessories.
c) If wrong charging mode is selected such as 6V charging mode for a 12V battery or 12V
charging mode for a 6V battery.

Power mode

The charger goes to Power mode in following situations:
a) Charger's terminals are short circuited or open circuited when charging is initiated.
b) Charging is initiated without any battery connected to the battery leads.
c) Attempt to charge a battery whose voltage is below 1V (for 6V battery) or 7.5V (for 12V
battery).
would continue to be on as long as battery remains greater or equal to
in the test panel would indicate a problem.
2
2
POWER
1
13