Idiomas disponibles
Idiomas disponibles
3. Locate holes at front and back of cabinet side near
top of unit. Position the cabinets so that these holes
align. Connect the two cabinets in the front and
back by inserting M6 x 16 mm hex bolt from inside
of one cabinet into the other. Secure using an M6
flange nut and 10 mm socket with ratchet wrench.
(See Figure 3)
NOTE: The back set of holes are optional and
provide additional stability.
Figure 3
M6 x 16 mm
Bolt
Back Hole
4. Attach previously removed slides to top drawer
starting from the back of the drawer. Once slides
are attached to drawer, flip the gray tabs back
down and push back in to lock the drawer.
(See Figure 4)
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
5. Insert drawer and slide combination back into the
M6 Flange
Nut
Front Hole
6. Each cabinet has four pre-threaded inserts on the
top drawer track of the cabinet. (See Figure 5)
NOTE: Make sure the drawer slides are
completely straight to ensure proper
installation of drawer.
NOTE: Halfway through inserting the drawer
and slide combo into the cabinet, you may
meet resistance. This is normal. Work the
drawer left and right until the resistance is gone
allowing the drawer to slide in.
Figure 5
side. Attach support bracket to outside of both
cabinets using four M6 x 20 mm bolts per bracket.
(See Figure 6)
Figure 6
1123 IH-11258
