Idiomas disponibles
Idiomas disponibles
Disassembly
• Pull back the clamping sleeve (A), hold and remove the tool.
7.3 Depth guide (Fig. 3)
You can pre-adjust the drilling depth and / or repeat this adjustment using the depth stop. Insert the necessary piercing tip. install
the depth stop in the hole of the auxiliary handle and adjust the necessary depth.
7.4 Dust protection cover (Fig. 4)
Slide the device of the dust cover over the drill before performing a vertical drilling with the hammer, above its head.
7.5 Installation of the auxiliary handle (Fig. 5)
The auxiliary handle can be installed for left or right handed users.
Always use the tool with the correct auxiliary grip assembly.
Loosen the auxiliary handle by unscrewing it.
For right-handed users, slide the auxiliary grip flange over the collar behind the chuck, handle to the left.
For left-handed users, slide the auxiliary handle flange over the collar behind the chuck, handle to the right.
Rotate the side handle to the desired position and tighten it.
7.6 Selection of the mode of use (Fig. 6)
The ROTARY HAMMER can be used in the following modes of use.
Rotary drilling
To screw and drill in steel, wood and plastic.
Percussion Drilling
Simultaneous rotation and percussion for drilling in concrete and masonry
KEEP WORKiNG
Built to Exceed
Keep Working
10
R M
2 6 0 4
