Idiomas disponibles
Idiomas disponibles
7 BEFORE YOU BEGIN THE WORK
• Examine the place where the machine should be used to detect the presence of electric cables, as well as hidden gas and water
pipes, using a pipe locating device.
• Before connecting the machine to the power supply winch, make sure that the power supply voltage corresponds to the voltage
indicated on the disinformation plate.
7.1 Installation and change of tools (Fig. 1)
The machine is equipped with an SDS-plus fixing system.
• Clean Chisel and brill bits and grease them by applying a thin layer of machine grease before uninstalling them.
For assembly
• Pull back the clamping sleeve (A) and hold it.
• Push and turn the dust-free tool into the tool holder as much as possible. The tool will lock automatically.
• Verify that it is locked by pulling the tool. Removal of the SDS-plus tool
• Pull back the clamping sleeve (A}, hold and remove the tool.
Accessories may be hot after use. Do not touch the tip of the accessory with your hand.
Always wear protective gloves to remove the accessory
7.2 Assembly / Disassembly of the auxiliary chuck for drilling in steel, wood and plastic 13 mm (Fig. 2)
Mounting:
• Pull back and hold the SDS chuck locking sleeve A.
• Clean the adapter pin and apply a grease tip to it.
• Push the auxiliary chuck into the SDS chuck.
• Turn slowly to the right.
• Release the locking sleeve A.
KEEP WORKiNG
Built to Exceed
Keep Working
09
R M
2 6 0 4
