Idiomas disponibles
Idiomas disponibles
Opening your life
1) As Figure 7, slide the end rail into the 1st sleeve, slide the middle rail into the 1st sleeve;
2) As Figure 8, slide the 2nd sleeve to the other end of middle rail, slide the top rail into the 2nd sleeve;
3) Remove the plastic lm on the end rail , cut the plastic cable tie on the screw rod "A";
4) As Figure 9, pull the screw rod "A" along with inner chain to the end of top rail ;
5) As Figure 10, undo the nut & spring;
6) Tight the nut to the right position as shown in Fig.9, cut the plastic cable tie on sprocket, then whole rail assembled
nished.
Installation recommendations
Remember there are speci c standards that have to be strictly followed regarding the safety rules of electrical installations
and automatic gates and doors.
As for the legal requirements and standards that must be adhered to, please take notice of the following points to ensure
maximum safety and reliability of your installation.
1) Before installing, check the surrounding environment. Carefully evaluate any hazards which could be physical damage
(transiting vehicles, parts of trees falling etc.), possible contact with persons bodies (insects, leaves, etc.), ooding hazards,
or any other exceptional events.
2) Check the main voltage numbers is the same as the numbers that are given on the rating plate and in this manual.
3) Check and make sure if there is suitable electrical protection against short circuits/power spikes and proper earthed on
the main supply.
Remember the unit having main voltage running through it (electrocution hazard, re hazard).
4) Take care with the control unit; the parts may be subject to damage if the control unit is abused.
5) Make sure that you have all the necessary materials, and they are suitable for this kind of use.
6) Read all the instructions thoroughly, and make sure they are understood before attempting to install the opener.
7) Before starting the installation carefully analyze all the risks relating to automating the door. Verify that the door is auto-
mated in a sound condition and that the mechanisms are in good working order. Observe the safety margins and mini-
mum distances.
8) Carefully evaluate the safety devices to be installed and the right place to install them; always install an emergency stop
device for power interruption to the opener if it is required.
9) Once the risks have been analyzed, install the opener and relative safety devices, emergency stop and/or photoelectric
cells.
9
1
