Jimmy HW9 Pro Max Manual De Instrucciones página 10

2. If the product is long idled , please charge the battery
within every 3 months. (Be sure to use the power
cord supplied with the product to charge)
3. When not charging, please unplug power cord from
the socket to prevent the danger of accidental touching.
Hot drying function
Under charging mode, press mode button to enter hot
dry mode. Hot air will dry entire air path including
burshroll, dust cup and dirty water tank for about 0.5
hour and then only dry brushroll for another 2.5 hours.
In the first 0.5 hour full air path drying, vacuum motor
will work to send hot air through the full air path.
To stop drying air path and only keep brushroll drying for
silent drying mode, press on/off button, vacuum motor
will not work in this mode.(Fig 11)
To turn on and turn off hot air drying function, press
mode button.
Brushroll & air path self-cleaning function
In charging mode, press the self-cleaning button to
enter cleaning mode (Fig 11), and after completing self-
cleaning, the machine enters the brushroll hot drying
mode automatically; Self-cleaning process can be stopped in advance by pressing on/off button or mode
button, and product will return to the charging mode. Fan will be turned off with a delay of 3mins.
Note:
1. Self-cleaning mode is only to clean floorhead air path and hardfloor brushroll.
2. Before turning on the cleaning mode, please empty the dirty water in the dirty water tank, check that the
machine is firmly placed on the charging base, the power cord is plugged into the power socket, the power
cord is connected to the charging base, and the clean water tank retains at least 1/2 of the water; After
completing the self-cleaning, clean the dirty water tank again;
3. When the battery is less than or equal to 10% power, the self-cleaning mode cannot be turned on, and it
can be turned on normally after charging for a period of time.
Clean water tank empty indicator
1. When using the water spray function, if "
water, fill in water", please turn off the machine and add water to the clean water tank.
2. When using the self-cleaning mode, if it is detected that there is no water in the clean water tank,
" " indicator appears in screen and the brushroll self cleaning will be stopped.The voice reports "No
clean water, please fill water". To continue self cleaning, please add water to the clean water tank and
empty the dirty water tank, then restart self clean mode.
Fill up clean water tank
Fill up clean water tank: Remove the clean water tank and lift the water filling plug of the clean water tank or
directly open the water filling plug of the clean water tank, expose the water inlet hole, pour clean water and
cleaning solution in,, and press the water filling plug down to install it to the end, and install it back into the
clean water tank. (Fig 12)
Note:
When adding clean water, you can add the equipped cleaning solution in the ratio of about one bottle cap to
one full tank of clean water.
8
11
Charging mode Self-clean mode Air drying mode
12
13
" indicator appears in screen and the voice reports "No clean
Water filling plug Water filling mouth
Mute button