Xiaomi C34WQBA-RGGL Guia De Inicio Rapido página 3

English
Specifications
Model: C34WQBA-RGGL
Power Input: 24 V 2.71 A DP Maximum Refresh Rate: 180 Hz
Rated Power *: 65 W Max. HDMI Maximum Refresh Rate: 100 Hz
Screen Size: 34" Tilt: -5° to +21°
Aspect Ratio: 21:9 Storage Temperature: -20°C to 60°C
Maximum Resolution: 3440 × 1440 Operating Temperature: 0°C to 40°C
Recommended Resolution: 3440 × 1440 Operating Humidity: 20%–80% RH
* The power of the power adapter is not included.
* The product nameplate is located on the bo om of the monitor.
When menu is not displayed on the monitor.
Short press to right. Enter the main menu.
Short press to up/down. Open brightness.
Short press to le .
Open signal source switching list.
Turn the monitor on /Open the shortcut menu.
Short press the middle.
Press and hold for 3 seconds.
External AC Adapter Specifications
Model Identifier: AY65FA-AF2402712-EU
Input Voltage: 100-240 V AC
Input AC Frequency: 50/60 Hz
Output Voltage: 24 V DC
Output Current: 2.71 A
Output Power: 65.04 W
Manufacturer: Dongguan Aoyuan Electronics
Technology Co., Ltd.
Result
When main menu is displayed on the monitor.
Enter/select.
Switch menu adjusting values.
Return.
Enter/select.
Shutdown.
Wall mounting
• For installation methods and precautions, please refer to the installation guide of the wall mount you purchased.
• The wall mount must be purchased separately.
• Tip: This product is compatible with wall mounts that have a hole spacing of 75 × 75 mm.
• The bolts used to secure the wall mount must meet the following requirements: Quantity: 4; Thread: M4; Length: 10 mm.
• Lay the monitor flat, with its back facing upwards. Use your finger to press the spring clip that joins the base to the monitor and remove the base.
• Note: When removing the base, be careful not to pinch your finger in the spring clip.
• Follow the wall mount user manual and install the wall mount onto the bolts that are built into the housing back.
Issue Possible Cause
No power.
Unable to turn on.
Image is dark. Brightness/Contrast not adjusted properly.
Image is ji ery or has ripples.
Interference.
No image on the screen. No signal, entering sleep mode.
The monitor displays that the
Resolution is incorrect.
current resolution is not supported.
Secure the wall
mount as shown
in the picture.
Troubleshooting
Solutions
Make sure the power adapter is plugged in properly.
Adjust the brightness and contrast.
Keep the monitor away from electronic devices that
may cause electrical interference.
Turn on the computer.
Make sure the computer's graphics card is working properly.
Make sure the cable is plugged in properly.
Use the specified recommended resolution se ings.