Kohler K-1243 Instrucciones De Instalación

R
INSTALLATION
INSTRUCTIONS
BEFORE YOU BEGIN
NOTES
S
Observe all local plumbing and
building codes.
S
Carefully inspect the new apron
for damage.
S
The apron must be installed
before the finish floor and wall
materials are installed.
TOOLS AND MATERIALS RECOMMENDED
S
Shimming material, as necessary
Tape Measure Screwdrivers
INSTALLATION
INSTALL THE
BATH/WHIRLPOOL
S
Install bath/whirlpool according to
the instructions included with the
product.
S
Make sure 2x4 studs are located
at front corners of bath. These will
be required when installing the
apron.
NOTE:
Before installing the apron,
fill the bath with water and test the
drain system for leakage. If
applicable, test the whirlpool system
for leakage and proper operation.
1011309-2-A
REMOVABLE BATH/
WHIRLPOOL APRON
S
The apron is designed to have the
finish wall materials (1-1/2" (3.8cm)
max.) go over the apron columns,
and finish floor materials (2" (5cm)
max.) to butt up against the channel.
S
The apron can be used as access to
the whirlpool pump and controls,
however, additional access may
make servicing of the pump and
controls easier.
Drill/Drill Bits
2x4 Stud
Español, Página 5
Français, Page 9
K-1243
Pencil Square
2x4 Stud
E2001 Kohler Co.
1 1