Assembly Procedure - Quick TOTEM TM 600 Manual Del Usuario

BEFORE USING THE CAPSTAN READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST "QUICK
WARNING: the Quick
Do not use the equipment for other purposes.
Quick ® shall not be held responsible for damage to equipment and/or personal injury, caused by a faulty use of the equip-
ment.
The capstan is not designed for the loads that might occur in extreme weather conditions (storms).
Always deactivate the capstan when not in use.
For improved safety we recommend installing at least two anchor capstan controls in case one is accidentally damaged.
We recommend the use of the Quick
The contactor unit or reversing contactor unit must be installed in a point protected from accidental water contact.
THE PACKAGE CONTAINS: capstan - reversing contactor unit - base gasket - handle - bolts and screws (for assembly) -
drill template - user's manual - conditions of warrant.
TOOLS REQUIRED FOR INSTALLATION: drill and drill bits: Ø 5 mm (13/64"), Ø 9 mm (23/64") and Ø 10 mm (13/32") - Ø 108 mm
(4"1/4) hollow mill; hexagonal wrenches: 10 mm and 13 mm.
"QUICK ® "ACCESSORIES RECOMMENDED: anchoring RL control board (mod. 800) - Waterproof hand helds R/C (mod. HRC1002)
- Foot switch (mod. 900) - Hydraulic-magnetic circuit breaker - Radio control RRC (mod. R02, P02, H02).

ASSEMBLY PROCEDURE

The following parts are to be checked before the holes are drilled. There must be no obstacles below deck to perform the installation in
the lower part. The thickness of deck must be such as to allow the capstan to be securely placed in position.
A
A Once the best position has been determined, drill the holes by using the drilling template.
B Install the back-flange (10) below deck.
C Secure the back-flange by using the screws (9).
E
8
D Remove the coupler (3) by releasing the bush (2) with the lever (1). Remove the capstan base ring (5) by loosening the screws (4)
that secure it to the base (7).
E Lower the capstan from the top of the deck by fitting the gasket (8) between the deck and the capstan base.
F Secure the capstan base to the back-flange by using the screws (6). Apply a medium-strength adhesive to the screw threads.
G Put the capstan base ring (5) in place and secure it with the screws (4). Install the coupler (3) and tighten the bush (2).
Connect the power cables coming from the reversing contactor unit to the electric motor.
WARNING: before wiring up, be sure the electrical cables are not live.
TOTEM 600/1000/1100 - REV005A
® capstans are designed to weigh engineered for capstan operation.
® hydraulic-magnetic switch as the motor safety switch.
B
F
6
® " DEALER.
C
10
9
10
G
7
INSTALLATION
1
2
GB
D
3
4
5
7
11